Manuale TOMY SR200 Digital Baby monitor

Manuale

GB

BABY UNIT

• GETTING TO KNOW YOUR MONITOR

PARENT UNIT

Microphone AC Adaptor jack

Power Indication Light

Power ON/OFF Button

Volume Control Buttons

Sound Level Lights Display

LINK Indication Light

Power Indication Light

Speaker

Sound Activated

Monitoring Light

Sound Activated

Monitoring Button

Power ON/OFF Button

Belt Clip/Battery

Compartment Cover

AC Adaptor Jack

•••

Low Battery on the Parent Unit

Power Indication Light will change

from solid green to ashing red.

Alarm tone on

Parent Unit

Alarm Meaning

Indications on the Parent Unit

Out of range

LINK Indication Light will change

from solid green to ashing red.

(Continuous)

3 beeps

••••••••

Fig.1 Fig.2

Fig.3

• PARENT UNIT

Unscrew the battery compartment cover from the back of the unit (N.B: this

may already be supplied loose). Next, link the plug on the end of the battery

pack connector to the socket inside the unit, pushing the plug rmly into

the socket until it clicks. Place the battery pack into the compartment and

screw the cover back into position. See Figure 1.

Ensuring the power cable is correctly connected, plug your Parent Unit into

the mains supply and charge for a full 7 hours. See Figure 2. You can use

your monitor while it is charging by following the ‘SET UP’ guide below.

Important! Your Parent Unit will not function without rst inserting the battery pack.

• BABY UNIT

The Baby Unit is powered by your domestic mains supply, using the power adaptor supplied.

Connect the adaptor to the back of the unit as shown in Figure 3.

Position the Baby Unit at least 1 metre away from your baby, ensuring all parts are kept out of

reach. Under no circumstances should you place any parts of the monitor in or on a cot. For

best performance, we recommend that the monitor is placed no further than 3 metres away

from your baby.

• SET UP

• POWER ON

Make sure both the Baby and Parent Units are plugged into the mains and that the Parent Unit has its battery pack

installed (see above). The units should stand at least 1 metre apart.

Activate the Baby Unit by pressing and holding the ON/OFF Button

on the back of the unit until the green Power

Indication Light on the front lights up.

Next, activate the Parent Unit by pressing and holding the ON/OFF Button

located on the back (next to the battery

compartment cover) until the green light illuminates.

Note: If the Parent Unit is switched on before the Baby Unit, an out-of-range alarm will sound if the Baby Unit is not

switched on within 30 seconds.

• POWER OFF

Switch off the Parent Unit by pressing and holding the ON/OFF Button

until the green light goes out.

Then, press and hold the Baby Unit’s ON/OFF Button

until the light goes out.

• BABY AND PARENT UNIT CONNECTION

As each unit activates, the LINK Indication Light

on the Parent Unit will ash as both Units auto-search and link to

each other. Once a connection is made between Baby and Parent Units, the LINK Indication Light will glow green

constantly and normal monitoring will start. The Sound Level Lights Display reacts to sound: the louder the sound, the

more lights illuminate.

• ALARM MODES

Identify the cause of an audible alarm by using the following table; should you be unable to identify or rectify the

cause of the problem, please refer to the Simple Solution Guide in these instructions.

GB

2

3

2 3

Valutazione

Maggiori informazioni su questo manuale

Comprendiamo che sia bello avere un manuale cartaceo per i tuoi TOMY SR200 Digital Baby monitor. Puoi sempre scaricare il manuale dal nostro sito web e stamparlo tu stesso. Se desideri avere un manuale originale, ti consigliamo di contattare TOMY. Potrebbero essere in grado di fornire un manuale originale. Stai cercando il manuale del tuo TOMY SR200 Digital Baby monitor in un'altra lingua? Scegli la tua lingua preferita sulla nostra home page e cerca il numero del modello per vedere se è disponibile.

Specifiche

Tutti i manuali per TOMY Baby monitor
Altri manuali di Baby monitor

Domande frequenti su TOMY SR200 Digital Baby monitor

Il nostro team di supporto cerca informazioni utili sul prodotto e risposte alle domande più frequenti. Se trovi un’inesattezza nelle nostre domande frequenti, ti preghiamo di farcelo sapere utilizzando il nostro modulo di contatto.

Prodotti correlati

Manuale

TOMY TFV600 Digital Audio Baby monitor

Manuale

TOMY SR325 Digital Baby monitor

Manuale

TOMY TDV450 Digital Video Plus Baby monitor

Manuale

TOMY TA100 Classic Baby monitor

Manuale

TOMY TD300 Digital Baby monitor

Manuale

TOMY TD350 Digital Plus Baby monitor

Manuale

TOMY TF575 Digital Audio Baby monitor

Manuale

TOMY TF550 Digital Audio Baby monitor

Categorie correlate