Manuale Muse M-1230 BT Autoradio

Manuale

1. Do not attempt to modify the unit. Modifying the unit may cause an accident.

2. Installation or servicing of the unit by persons without training and experience in electronic

equipment and automotive accessories may be dangerous and could expose you to

the risk of electric shock or other hazards.

3. Stop the vehicle before carrying out any operation that could interfere with your driving.

4. Keep the volume at a level which you could hear sounds from outside the vehicle.

5. Do not work in extremely high or low temperature. Be sure the temperature inside the

vehicle is between +60°C and -10°C before turning on your unit.

6. When replacing the fuse(s), the replacement must be of the same amperage as shown

on the fuse holder.

7. Do not block vents or radiator panels. Blocking them will cause heat to build up inside

and may result in re.

8. Using this unit without running the engine can result in battery drainage

9. Use only in cars with a 12 volt negative ground.

10. After completing the installation and beginning to play the unit(including replacing the

battery), please remove the front panel at rst, and then press RESET button on the

base with pointed object (such as ball-point pen) to set the unit to initial status.

11. Before you install the unit, remove absolutely the two transportation screws on top of

the unit.

When you unpack your new car radio, make sure that you have removed all the accessories

and information papers:

Main unit

User manual

Accessories:

Caution!

- Make sure to connect the color coded leads according to the diagram. Incorrect

connections may cause the unit to malfunction or damage the vehicle’s electrical system.

- Make sure to connect the speaker (-) leads to the speaker (-) terminal. Never connect

the left and right channel speaker cables each other or to the vehicle body.

- Make sure all the connections are completely correct before turning on your unit.

Do not connect the ignition wire (red) and the battery wire (yellow), it may cause

a short circuit, even result in re.

1. Remove the outer trim frame.

2. Select a position where the screw holes of the mounting bracket supplied with the car

and the screw holes of the main unit become aligned (are tted).

3. Tighten the screws. And then fasten them to the car.

Install the unit

- Method 1: DIN Front-Mount

- Method 2 DIN Rear-mount (For Japanese car)

M-1230 BT

GB - 1

GB - 6GB - 5

User Manual

CAR RADIO CD/MP3 PLAYER WITH USB & SD

Please read the instruction carefully

before operating the unit.

PRECAUTIONS UNPACK YOUR UNIT

INSTALL AND REMOVE THE UNIT

CONNECTION

LOCATION OF CONTROLS BASIC OPERATION

SOUND FEATURES

LISTENING TO THE RADIO

English

GB - 2

GB - 7

GB - 3

GB - 8

Notice on disc

Use such discs may cause malfunction or breakdown of the internal mechanism:

with large scratches; with irregular shape; cracked; with any cellophane tape or other

glue on it or with peeling off marks; with protection sheet; equipped with stabilizers, etc.

* Do not attempt to load more than one disc.

* Only 12cm discs are compatible.

* New discs may have some roughness around the edges. Before load such disc into the

player, use a ball-point pen or the like to remove any roughness from the edge of the disc.

* If there is a scratch, dirt or ngerprints on the disc, it may cause tracking error. Before

playing, clean the disc with a clean cloth. Wipe the disc from the center out.

* Don’t store discs in places with high temperatures or high humidity, they can become

warped. After playing, store the disc in its case.

Install the front panel

Insert the panel into the housing and make sure the panel is properly installed.

Otherwise, abnormality occurs on the display or some keys will not function properly.

Detach the Front Panel

1. Press button on front panel and then pull off the front panel.

2. For safekeeping, store the front panel in the supplied protective case immediately

after being removed.

Note: Never put any objects into the front panel.

Remove the unit

1. Detach the front panel. (Refer to upper part)

2. Take out the outer trim frame.

3. Insert the keys supplied to the unit at the both sides of the unit (shown as illustrated)

until they click. Pulling the keys makes it possible to remove the unit from the dashboard.

1. (release) button

2. Mic

3. Disc slot

4. LCD display

5. disc eject button

6. PWR button (Power on/off)

7. 9/ button

8. 8/ button

9. EQ button

10. SELECT/ VOLUME knob

11. 7/ MOD (mode), (hang up/ reject call) button

12. AMS/ (Search, Auto preset, Dial /Answer) button

13. LOUD/BAND button

14. 1/PAU (Play/pause) button

15. 2/INT (Intro) button

16. 3/RPT (repeat) button

17. 4/RDM (random) button

18. 5/*/DIR- button

19. 6/#/DIR+ button

20. PTY button

21. 0/DSP (Display) button

22. AUX IN jack

23. USB port

24. AF/T-MENU button

25. TA button

26. SD card slot

27. RESET button

Turning on/off the unit

Press PWR button to turn on the unit. When the unit is on, press PWR button to turn

off the unit.

Note: When the unit is off, press any key except to turn on the unit.

Selecting the mode

After the unit is on, press 7/MOD button repeatedly to select different source mode:

RADIO, BLUETOOTH ( “PHONE” ), CD, USB, CARD, AUX

Note: The Bluetooth ( “PHONE” ) mode can only be selected when your mobile phone

is connected to the unit.

Display mode

Press 0/DSP button to change display mode.

Reset the unit

Operating the unit for the rst time or after replacing the car battery, you must reset the

unit. To set the unit to initial status, press RESET button located on the base with a pointed

object. When some errors occur in display, you can also reset the unit, but it will erase

the clock setting and some memorized functions.

Volume adjusting:

To increase or decrease the sound level, rotate SELECT/VOLUME knob clockwise or

anti-clockwise.

Setting the Sound:

Repeatedly press SELECT/VOLUME knob to select the desired mode in the following

order: “BAS” (Bass) “TRE” (Treble) “BAL” (Balance) “FAD“ (Fader) ”BEEP”

(Beep on/off) “TAVOL” (TA volume) “EON” (EON on/off) “VOL” (Volume). After

selecting the desired mode, you can adjust the level by rotating the SELECT/VOLUME

knob.

Preset equalizer

When you are listening to pop music, classic music or rock music, use the equalizer to

adjust the sound quality. Repeatedly press EQ button to select different equalizer mode

in following order: FLAT POP ROCK CLASSICS EQ OFF.

Switching Loudness On/off

Press and hold LOUD/BAND button until “LOUD ON” shows on display to activate

LOUDNESS function. By this function, you can increase the low frequency, which can

improve sound sensitivity. Press and hold this button again until “LOUD OFF” shows on

display to cancel LOUDNESS function.

Selecting band

In tuner mode, repeatedly press LOUD/BAND button to select bands in following order:

FM1 FM2 FM3.

Manual/automatic tuning

- Manual Tuning

Press and hold button or until “MANUAL” shows on display, then press button

or continuously to select a station upward or downward. Press and hold button or

to tune the station with a faster speed.

- Automatic Tuning

Press or once to start auto search. “SEARCH” shows on display. It will automatically

search up or down for an available station.

Press or again to stop scanning.

Scanning/memorizing stations automatically

- By AMS button

In tuner mode, press and hold AMS button until “SEARCH” appears on display. It will

start scanning and the 6 strongest stations will be stored into the corresponding preset

number button automatically.

- By number button 1-6

1. Tune to a station by or button.

2. Press and hold one of the 1-6 Number buttons for 2 seconds until LCD shows the

corresponding number, which indicates that station is stored in the corresponding

number button.

Note: The unit can be stored up to 6 stations for each band.

Retrieving the preset stations

Press number button 1-6 to listen to corresponding station.

-- RDS (Radio Data System) Operations --

This unit has a built-in RDS decoder system that supports broadcast stations transmitting

RDS data. This system can display the name of the broadcast station being received and

can automatically switch to the broadcast station with the best reception as you travel on

long distances (AF switching). A trafc announcement broadcast from a RDS station, no

matter what mode you are. Additionally, if EON information is received, enables automatic

switching of other preset stations on the same network and interruption of the station being

received with trafc information. This function is not available in some areas.

Alternative frequency (AF)

Press AF button to switch AF function ON or OFF.

When pressing the AF button briey, the AF switching mode is selected and the state of

the AF switching mode is displayed by “AF” indicator in display.

Segment off: AF switching mode off.

Segment on: AF switching mode on, and receive RDS information.

Segment ashing: AF switching mode on, but RDS information is not received yet.

- Regional Program Operation

When AF function is ON, press and hold AF button for 2 seconds to switch the region

mode ON or OFF.

Some broadcasting stations change their program from normal broadcasting to regional

broadcasting for a certain time period. When region is on, the current listening program

remains unchanged. When region is off, it allows the reception changing to regional station.

Trafc alarm (TA)

Press TA button to switch TA function ON or OFF.

Press the TA button shortly to turn on TA search mode.

When trafc announcement is transmitted:

1) If the unit is in Disc Play mode, it will switch to radio mode temporarily.

2) If the unit is in radio mode, it will switch automatically to the trafc announcement.

* TA interruption function: The current trafc announcement is cancelled by pressing TA

button shortly.

ALARM

“TRAF INF” will be displayed when an emergency broadcasting is received; meanwhile

sound output level will be adjusted to the preset output level automatically when the

volume control is set at minimum.

Program type selection (PTY)

When PTY is selected, the radio starts to search corresponding PTY information, and

stops when the corresponding PTY information is detected.

If corresponding PTY information does not exist any more, PTY is automatically stopped

to normal mode.

Using PTY button to Select Program

1) Press PTY button once. When “PTY” appears on display, press number button 1-6

repeatedly to select below programs:

Button 1: NEWS/ AFFAIRS / INFO

Button 2: EDUCATE/ DRAMA/ SPORT

Button 3: VARIED/ CULTURE/ SCIENCE

Button 4: FINANCE / CHILDREN/ WEATHER

Button 5: PHONE IN / SOCIAL / RELIGION

Button 6: TRAVEL/ LEISURE/ DOCUMENT

2) In PTY MUSIC group you can select the program type as below by using button 1-6.

Button 1: ROCK M /POP M

Button 2: LIGHT M/EASY M

Button 3: OTHER M/CLASSICS

Button 4: COUNTRY/JAZZ

Button 5: OLDIES/NATION M

Button 6: FOLK M

GB - 4

GB - 9

AR-3768 IB MUSE 001 REV0 GB.indd 1 2016/4/26 10:33:24

Valutazione

Maggiori informazioni su questo manuale

Comprendiamo che sia bello avere un manuale cartaceo per i tuoi Muse M-1230 BT Autoradio. Puoi sempre scaricare il manuale dal nostro sito web e stamparlo tu stesso. Se desideri avere un manuale originale, ti consigliamo di contattare Muse. Potrebbero essere in grado di fornire un manuale originale. Stai cercando il manuale del tuo Muse M-1230 BT Autoradio in un'altra lingua? Scegli la tua lingua preferita sulla nostra home page e cerca il numero del modello per vedere se è disponibile.

Specifiche

Tutti i manuali per Muse Autoradio
Altri manuali di Autoradio

Domande frequenti su Muse M-1230 BT Autoradio

Il nostro team di supporto cerca informazioni utili sul prodotto e risposte alle domande più frequenti. Se trovi un’inesattezza nelle nostre domande frequenti, ti preghiamo di farcelo sapere utilizzando il nostro modulo di contatto.

Prodotti correlati

Manuale

Muse M-1009 R Autoradio

Manuale

Muse M-199 BT Autoradio

Manuale

Muse M-1229 BT Autoradio

Manuale

Sony CDX-GT530UI Autoradio

Manuale

Sony XAV-63 Autoradio

Manuale

Sony CDX-GT24 Autoradio

Manuale

Sony XAV-AX200C2 Autoradio

Manuale

Sony CDX-M9900 Autoradio

Categorie correlate