Manuale Candy CBG 61 X Cappa da cucina

Manuale

ENGLISH

INSTALLATION

The appliance can be used in both the filtering and ducting version. In the Filtering version (Fig. 4), the air and

vapours conveyed by the appliance are depurated by charcoal filters and recirculated around the room. ATTENTION:

When using the filtering version, charcoal filters must be installed (the charcoal filters are not supplied). In the Ducting

version (Fig. 3), cooking vapours and odours are conveyed straight outside by a disposal duct which passes through

the wall. Use of charcoal filters is therefore unnecessary.

The following operations are essential for assembly: – Cut a hole in the bottom of the pensile cupboard in

order to settle the appliance (Fig.1). – Set the power supply near the appliance. – Prepare the air venting hole if your

appliance is to be installed in the ducting version.

To install the appliance, adjust the position of the clasping side springs by means of the proper screws (Fig. 2),

according to the thickness of the bored panel to which it is going to be anchored.

Insert the appliance in the pensile cupboard and lock it by means of the side springs. Use the holes which have

already been made in the casing of the appliance to definitively fix it by means of additional screws.

Ducting version : connect the disposal duct to the air evacuation pipe of the hood. Use a flexible pipe and lock

it to the air evacuation pipe of the hood with a metal hose clamp (pipe and clamp are not provided). Make the electrical

connections.

Filtering version : connect an adequate pipe to the connecting flange of the appliance so that it conveys the

air up to the top of the pensile cupboard (pipe is not provided). Make the electrical connections.

OPERATION

Controls (Fig. 8):

A = LIGHT switch.

B = MOTOR switch. Position 0: motor off. Position 1: motor on Ist speed. Position 2: motor on 2nd speed. Position

3: motor on 3rd speed.

C = Operating motor warning light.

To gain access to the interior of the appliance remove the metal grille by slidying the two side stops towards the

center (Fig.5).

Grease filters: depending on the versions, the hood features different types of grease filters:

Metal filter (Fig. 7A): this filter is made of metal and is located inside the metal grid; depending on the hood model

purchased by you, two or just one metal filter can be fitted. The filter/s must be periodically cleaned, according to use,

but on average every two months. Wash the filter/s with neutral detergent.

To remove the filter, remove the metal grid by sliding the two side stops towards the centre (Fig. 5); afterwards,

remove the two metal filter stops (F) and take out the filter.

Synthetic filter (Fig. 7B): this filter is made of white synthetic fibre and is located inside the metal grid; it cannot be

washed, but should be periodically

replaced according to use (at least every two months).

To remove the filter, remove the metal grid by sliding the two side stops towards the centre (Fig. 5); afterwards,

remove the two metal filter stops (M) and take out the filter.

When using the filtering version of the appliance, the charcoal filters must be changed according to use (Fig.6),

usually every six months. Remove the filters rotating them and replace them rotating into the opposite direction.

To gain access to the light bulbs, remove the grille (Fig. 5) and unscrew the bulbs. Replace with a bulb of the same

type.

DEUTSCH

INSTALLATION

Das Gerät kann sowohl im Umluftbetrieb, als auch im Abluftbetrieb eingesetzt werden. Im Umluftbetrieb (Abb.4)

wird die Luft zusätzlich durch den (einmotoriges Gerät) / die (zweimotoriges Gerät) Kohlefilter geleitet und in den

Raum zurückgeführt. Pro Motor ist somit ein Kohlefilter erforderlich (Die Kohlefilter werden nicht mitgeliefert). Im

Abluftbetrieb wird der Kochdunst durch Abluftrohre ins Freie geleitet (Abb. 3). Kohlefilter sind im Abluftbetrieb nicht

erforderlich.

Auschnitt im Hängeschrank: Im Boden des Hängeschrankes ist ein Ausschnitt anzubringen, der dem

einzusetzenden Gerät entspricht (Abb. 1).

Justierung der Montagehilfe: Die seitlich am Gerät angebrachten Federn dienen als Montagehilfe, die das

Gerät im Ausschnitt des Hängeschrankes festhalten. Um einen einwandfreien Sitz des Geräts zu gewährleisten,

müssen diese Federn auf die Stärke der Platte, in der sich der Ausschnitt befindet, eingestellt werden. Dies geschieht

durch Drehen der entsprechenden Einstellschrauben (Abb. 2).

Valutazione

Maggiori informazioni su questo manuale

Comprendiamo che sia bello avere un manuale cartaceo per i tuoi Candy CBG 61 X Cappa da cucina. Puoi sempre scaricare il manuale dal nostro sito web e stamparlo tu stesso. Se desideri avere un manuale originale, ti consigliamo di contattare Candy. Potrebbero essere in grado di fornire un manuale originale. Stai cercando il manuale del tuo Candy CBG 61 X Cappa da cucina in un'altra lingua? Scegli la tua lingua preferita sulla nostra home page e cerca il numero del modello per vedere se è disponibile.

Specifiche

Tutti i manuali per Candy Cappe da cucina
Altri manuali di Cappe da cucina

Domande frequenti su Candy CBG 61 X Cappa da cucina

Il nostro team di supporto cerca informazioni utili sul prodotto e risposte alle domande più frequenti. Se trovi un’inesattezza nelle nostre domande frequenti, ti preghiamo di farcelo sapere utilizzando il nostro modulo di contatto.

Prodotti correlati

Manuale

Candy CCT 685/1N Cappa da cucina

Manuale

Candy CCE190X Cappa da cucina

Manuale

Candy CGM74X Cappa da cucina

Manuale

Candy CCE119/1N Cappa da cucina

Manuale

Candy CFT 92 W Cappa da cucina

Manuale

Candy CFT 161 FW Cappa da cucina

Manuale

Candy CBG52SX Cappa da cucina

Manuale

Candy CFT610/5X Cappa da cucina

Categorie correlate